Trailer Led Wire Kit Easy To Install Plug And Play Wiring Lamp Boat Diy Flush Locks Designed to apply the electric

Designed to apply the electric brakes on the trailer in the event of an accidental separation (breakaway) from the tow vehicle when coupled to a breakaway unit

10mmS) GAS100/5 8 18 215 500 100 100Nf (500mmL

Stamped 4177-35

2 x LM bearing set with marine seals

No power draw when no 12V load is active

Trailer Led Wire Kit Easy To Install Plug And Play Wiring Lamp Boat Diy Flush Locks Designed to apply the electricPLUG AND PLAY WIRING KIT TAIL LIGHTS 8x Super Bright LEDs with Enhanced Lens Optics ECEapproved IP67 100% Water proof 12V Only 150mm x 50mm x 23mm Water Submersible Fitting Instructions 1 Drill a 13mm hole for the wire outlet plug. 2 Remove the protective film from the 3M tape. 3 Push the cable and plug through the hole. 4 Line up the lamp and press firmly. 5 The lamp is held securely with high quality 3M tape. Wire Color for Trailer Kit Red Stop,